
Yesterday we posted a practice test that can take you on the path of Computer Networking. Continue this Computer Networking Practice Test. It is a CCNA Practice Test that helps you to identify which areas of the Cisco switching and routing concepts you are well-versed in and which areas need work. In case you miss any questions, adequate explanations have been provided. We highly recommend you Login / Register to take this test.
- 10 questions in all. There is no time constraint, so take your time. You need to score at least 80% to pass
- You can retake the test at any time. We recommend you share with friends too.
#1. ACEs in an access list should be entered in order of ------------.
Deal Score0
Login / Register
ACEs in an access list should be entered in order of more to less specific.
#2. Standard access lists should be applied as close to the ----------- as possible.
Deal Score0
Login / Register
Standard access lists should be applied as close to the destination address as possible.
#3. An inside local address is -------.
Deal Score0
Login / Register
An inside local address is a private address referencing an inside device.
#4. Use the image given to answer the following question. Which negotiation protocol, if any, was used to create the trunk?
Deal Score0
Login / Register
The output specifies mode as on; this indicates no negotiation was used.
#5. Use the image given to answer the following question. Which STP could not have been configured on this switch?
Deal Score0
Login / Register
Common Spanning Tree (CST) creates one spanning tree for all VLANs. The output indicates that there are 3 VLANs, but only 2 are forwarding. This can only happen with a per-VLAN or per-VLAN list STP.
#6. Use the image given to answer the following question. How many VLANs are on switch S2?
Deal Score0
Login / Register
This command only shows those VLANs allowed on the trunk; there could be more configured on the switch that are not allowed on this trunk.
#7. Use the image given to answer the following question. Which VLAN ID is the native VLAN?
Deal Score0
Login / Register
The first line of output specifies Native VLAN 99.
#8. If only IPv6 routing is used, which of the following commands is required for OSPFv3?
Deal Score0
Login / Register
The router-ID command in router configuration is required to start OSPFv3 if only IPv6 routing is used.
#9. A(n) ----------- must be configured before Telnet or SSH is used to reach the device.
Deal Score0
Login / Register
Until an IP address is configured, only a console connection can be used to access a Cisco device.
#10. Which type of cable is used to connect two PCs?
Deal Score0
Login / Register
A crossover cable is used to connect two PCs.
Results
-
HD Quiz powered by harmonic design